Wheel Assembly - SHOWJOE 24V-SUV1 Manual Del Operador

Fig. 1
Battery
charger
Power On
Green Red
2. Remove the battery once fully charged.
NOTE: A fully discharged battery at room temperature will
fully charge in 1 hr 50 mins.
IMPORTANT! Never allow the battery pack to become
fully discharged as this will cause irreversible damage to
the battery.
Assembly

Wheel Assembly

Tools required: Philips head screwdriver
1. Turn the ride-on SUV upside down.
2. Fix the front axle assembly into the bottom of the ride-on
SUV using eight ST4 x 12 truss head screws.
NOTE: Ensure the steering column sits inside the slot in
the center of the front axle assembly (Fig. 2).
Fig. 2
Front axle
assembly
Battery
Charging Charged
Green
ST4 x 12 truss
head screws
Steering
column
3. Slide a washer, a plastic bushing, a wheel, another washer
and finally a lock nut onto either side of the front axle.
Tighten both lock nuts using the socket wrenches before
installing the hub caps (Fig. 3).
Plastic
Washer bushing
Axle
Wheel
4. Insert the springs and rear suspension mounts into the
holes towards the rear of the ride-on SUV (Fig. 4).
Fig. 4
5. Push down on the rear suspension mounts and slide the
rear axle through both of them. Ensure the rear axle sits
under all four steel brackets and that the rear suspension
mounts are in tension (Fig. 5).
Fig. 5
7
Lock
nut
Washer
Rear
suspension
mount
Spring
Rear axle
Rear
suspension
mounts
Fig. 3
Hub cap