Troubleshooting - STERWINS PBC2-33B-AB.2 Instrucciones Legales Y De Seguridad

DANGER! Risk of injury due to accidental start.
therefore check the product using this section. In most cases the problem can
be solved quickly.
Probable causes
Problems
The fuel tank is empty.
The primer bulb was not
pressed enough.
Engine does
Spark plug is defective.
not start
The fuel tube is broken.
Engine lack
Spark plug is dirty .
of power or
engine does
not accelerate
Fuel mixing screw is set
incorrectly.
The lengths of two ends
Unsatisfactory
cutting
performance
Blunt or broken metal blade Sharpen or replace blade.
The metal blade is installed
Excessive
incorrectly.
vibration/
noise
Bolts/nuts are loose.
The engine
will not idle
Idle screw is set incorrectly.

5. TROUBLESHOOTING

Corrective actions
Refuel the fuel tank with properly mixed fuel.
Press the primer bulb 4-7 times or until fuel is
visible.
Clean the electrode or change with a new one.
Remove the spark plug and wipe up the fuel,
then pull out the starter rope 5-10 times to drain
out the fuel in cylinder.
Contact with the local service for repair.
Clean it.
Contact with the local service center for help.
Tap the trimmer head against the ground
automatically.
Make sure the metal blade aligns with the output
spindle.
Tighten bolts/nuts.
Contact with the local service center to adjust the
idle speed.
275
,
EN