Publicidad
Idiomas disponibles
Idiomas disponibles
In-ceiling Speaker 0E-ICF6560W
IN-CEILING SPEAKERS 6.5" HIGH PERFORMANCE SYSTEM
1
When laying loudspeaker cable
2
from ampli er to installation point,
be sure that the cable ends about
30 cm(12") beyond the wall cutout.
3
4
5
1
Speaker Operation Manual
Use enclosed template to mark out the
cutout, then simply cut along the line.
This is the only cut you'll need to make !
Installation
Installation
dimension(inch)
depth (inch)
Model
5.25"
7.05"
＞3.19"
6.5"
8.27"
＞3.46"
8"
10.16"
＞4.13"
Please connect the speaker cable
to the screw clamps. Ensure that
the polarity is correct.
Tighten clamp screws until you
can feel the frame,press rmly
against the ceiling.
This indicates that the clamp is
extended and is gripping the ceiling.
clamp
The grille cover of the in Wall/ in-ceiling
systems can simply be coated with
regular paint. If the grille cover of your
system comes with an additional coating
this must be removed before painting.
Equipment You Will Need
Besides template that is included, you must have a ladder and the equipment
shown below to make the installation go smoothy
Tape measure
Square-head
or Phillips-head
Speaker cable
screwdriver
stud nder
cutting tool
Sharp pencil
Troubleshooting
Problem
Possible cause
Bass too weak
connection cable wrongly
connected
Wiring Possibilities
In-ceiling Speaker 0E-ICF6560W
Wire cutter/stripper
Protective eyewear
Spade drill bit
Power drill
Solution
Check connection cable and
reconnect where necessary
2
Publicidad
