Hama 00040966 Manual De Instrucciones página 8

00040966bda 06.09.2007
Equipment
1. Automatic frequency scan on headphones
2. PLL technology for a stabile frequency
3. With integrated battery charging function
4. 863MHz UHF technology enables fault-free,
wireless transmission
5. Radio transmission through walls
6. Light-weight headphones provide high comfort
7. Automatic level control (ALC) and automatic
energy-saving function on the transmitter
Startup
The batteries (4) located in the headphones must
be fully charged before activating the headphones
(1). To do so, Place the headphones in the transmit
station (2), once you have connected the power
supply adapter (3) to the transmitstation (2) and
power supply (230 Volt). The green charging
control light (13) illuminates when proper contact
is made. If this is not the case, check whether the
charging socket is properly positioned on the
charging contacts (12). The batteries are fully loa-
ded after approximately 24 hours. (The green
charging control light (13) remains illuminated
when the batteries are fully charged).
Connect the audio cable (15) to the playback
device (TV, radio, HiFi, etc.) or headphone socket
or audio output (adapter 5 and 6 are included in
the delivery). Switch the device (e.g. stereo
equipment, TV, etc.) to the connected transmit sta-
tion. Set the volume to a normal room volume. The
red operating control light (14) should illuminate
provided that your sound source sends a NF
signal.
If the operating control light does not illuminate,
make sure the sound source is switched on and
increase the volume so that the NF signal is
received stronger and the control light is on. (If
you connect the transmit station to a mono device,
you may only receive sound on the headphones on
one side. In this case, you require a 3.5mm mono
adapter, Hama item 43374)
All manuals and user guides at all-guides.com
8:18 Uhr Seite 7
7
Note:
Some TVs switch off the speakers integrated in
the TV when the headphone socket is used. Adjust
the volume before connecting the transit station
audio cable (15) to the playback device.
1. Connect the headphones to the On/off switch
(10). The control light (11) on the headphone
illuminates red.
2. Put on the headphones and adjust the volume to
a comfortable level using the volume control (8).
3. If the reception is disturbed, press the frequency
radio button (7), until you have proper reception.
The control light (9) must illuminate green.
Note:
You can now move about freely with the head-
phones and listen to the music. Should there be a
signal disturbance, press the button for the auto-
matic frequency selection (7). You may need to
switch the transmit station to another frequency
channel (16). Three channels are available. You
should be approximately 5 meters away from the
transmitter for optimum frequency tuning. If the NF
signal remains off for longer than 1 minute or is
weak, the transmitting unit automatically switches
off. This energy-saving function protects your
radio headphones.
As soon as the signal is present, the transmitting
unit operates again.
Charging the batteries:
1. Switch off the headphones (1) using the On/off
switch (10).
2. To charge the batteries, place the headphones
on the transmit station (2) so the charging
contacts (12) fit into the headphone guide rails
on the transmitter.
3. The charging process begins automatically and
the green charging control light (13) displays the
charging process. Before using the radio
headphones for the first time, charge the
batteries for approximately 24 hours. An over-
charge function is integrated into the device,
however, the charging process should not
exceed 48 hours. Place then headphones on the
transmit station so they do not make contact