Motion BLINDS CM-06-E-R Manual De Instrucciones página 9

FCC Manual | FCC ID: ZY4CM06E
IC:28117-CM06E
Regulatory Information
1 FCC Information for User
This product does not contain any user
serviceable components and is to be used with
approved antennas only. Any product changes
or modifications will invalidate all applicable
regulatory certifications and approvals.
2 FCC Electronic Emission Notices
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
1. This device may not cause harmful interference
2. This device must accept any interference
received, including interference that may cause
undesired operation.
3 FCC Radio Frequency Interference
statement
This equipment has been tested and found to
comply with the limits for a class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful
communications.
Operation of this equipment in a residential area
may cause harmful interference, in which case the
user will be required to correct the interference
at their own expense. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna
Increase the distance separating the equipment
and receiver
Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected
Consult the dealer or an experienced radio/TV
technician for help
interference to radio
To satisfy FCC / IC RF exposure requirements,
a separation distance of 20 cm or more should be
maintained between the antenna of this device
and persons during device operation.To ensure
compliance, operations at closer than this
distance is not recommended.
EU Declaration
Hereby, Coulisse declares
equipment type CM-06-E-R is in compliance
whith directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the
following internet address: www.motionblinds.
com
Frequency range: 433 MHz, RF power: 2.32 dBm
Frequency range BLE: 2402 - 2480 MHz,
RF power: 3 dBm EIRP
Frequency range Thread: 2405 - 2480 MHz,
RF power: < 20 dBm EIRP
ISED Compliance
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada' s licence-exempt
RSS(s). Operation is subject to the following two
conditions: This device may not cause interference.
This device must accept any interference, including
interference that may cause undesired operation
of the device.
that the radio
9