Connecting The Monitor; System Installation - Konig Security SEC-TRANS10 Manual De Uso

ON/OFF
Button to switch the monitor ON or OFF.
CH (Channel select / Auto switch)
Press the button to switch between the 4 channels. The system presets to CH1 by default. Press the
bottom once to switch to CH2, press again to switch to CH3, press again to switch to CH4, press again
to switch to auto-scan mode.

Connecting the monitor:

1. Plug the 12 VDC adapter plug into the DC input jack.
2. Plug the adapter into a standard (100V-240 V) AC outlet. Press the ON/OFF button to turn on LCD
monitor.
3. A/V input can be connected with an external audio/video source
4. A/V output on the LCD monitor can be connected to a TV, monitor or DVR/VCR for recording.
Bracket Stand at the back of LCD monitor can be pulled out to put the LCD monitor on any solid and
fl at surface.

System Installation:

When installing the camera, check the reception of the LCD monitor fi rst before fi nal installation.
Select the same channel (Channel 1-4, as indicated on Channel Label) to be used on both the camera
and LCD monitor.
Channel selection on the camera
The camera can be set up in four different optional channels.
To set the channel selection switch, use a pointed object, e.g. a ballpoint pen, to select the desired
channel (No.1 or No.2 or No.3 or No.4) to position „ON". Only one channel is activated on one camera.
Camera Set to Camera Set to Camera Set to Camera Set to
Channel 1 Channel 2 Channel 3 Channel 4
Channel selection on the LCD monitor
When one camera is installed, select with the CH button the same channel as chosen on the camera. If
two or more cameras (CH2, CH3, etc.) are installed, press CH again to switch to the desired camera.
If pressed 4 times on the CH button (all LED indicators will light up), the monitor will switch to auto scan
mode and display all installed cameras in a sequence with 5 seconds interval. Press again the CH
button to stop the auto scan mode.
4