ASSEMBLY
17
1.
Align the corresponding hole of the MIDDLE BAR ( H ) and PARTITION ( E ) as figure
shown below.
2.
Align the corresponding hole of the MIDDLE BAR ( H ) and LEFT BACK PANEL ( F ) into
the corresponding hole of LEFT SIDE PANEL ( C ) as figure shown below .
3.
Insert the CAM LOCK ( 2 ) into the corresponding hole ( the direction of the notch is
aligned with the cam bolt as the figure shown below).
4.
Use a hand screwdriver to turn the CAM LOCK ( 2 ) clockwise to secure the cam bolt.
Make sure edge of both panel
align and even
CAM LOCK
2
×7
Please call for replacement parts or assistance: 1-888-568-3818
Young Chain Company Limited
The direction of the
notch of the cam
lock is aligned with
the cam bolt.
Page 22