Publicidad
Idiomas disponibles
Idiomas disponibles
M 140210500228022022
CONTROL PAD
•
When heater plug in. The heater will beep as it switches on. The heater starts on standby mode, displaying the
WiFi icon and the ON/OFF
•
To initiate heating, press the ON/OFF
the ECO mode state.
•
To
change
heating
ECO mode
•
To adjust the set temperature of any of the modes, You can then use the UP
adjust the temperature. Temperature range is from 5°C –50°C.
•
To set the timer, press the TIME button
digits will flash while setting and then the screen will return to heating mode. The timer icon on the screen will
show that the timer has been set. The heater will heat until the time has elapsed.
•
To schedule your heater to switch on later, press the
hours. The digits will flash while setting and then the screen will return to heating mode. The timer icon on the
screen will show that the timer has been set.The heater will switch on when the delay has elapsed.
•
To set the child lock, press and hold the UP
control panel will be locked out. To release, press and hold the down
indicating that all the buttons can be used again.
•
To set the display light, press the light button
Display:
Temperature or
timer settings
button.
button. You will see the ECO mode icon
mode,
press
the
Comfort mode
while the heater is in heating mode. Timer range is 1 – 24 hours. The
Mode display
Mode change
button
Keyboard lock
MODE
button
Anti-frost mode
TIME button while in standby mode. Delay range is 1 – 24
button. The padlock icon
. The displaylight cycles between, OFF, ON and Dimmed.
UP
Down
THERMEX HEATMEx
. This means the device is in
to
cycle
through
and DOWN
will appear on the screen and the
button. The padlock icon will disappear,
WIFI / Light
button
Timer
button
ON/OFF button
43
the
modes:
buttons to
Publicidad
