Charging Indications; Troubleshooting - MH MOTORHEAD MH-03-JS-B1-0-1 Manual De Instrucciones

20V ULTRA Jig Saw 2Ah KIT (MH-03-JS-B1-0-1)

- Charging indications

• Loosen the Fence Knobs with a hex key.
• Install the Fence on either side as needed.
• Adujst the Fence as needed.
• Tighten the Fence Knobs securely.
- To set the bevel angle
WARNING: Before making any adjustments ensure
the saw.
• Loosen both screw with a hex key.
• Adujst the angle of Base plate as needed.
• Tighten both screws securely.
- Laser and LED work-light
• Press the Laser button (A in the functional description) to
• The LED work-light can light prior to motor running if you
press the switch lightly, which keep the work area to be
lighted for checking clearly at first, and it lights also during
your operation.
General Operating Instructions
• Never use a blade unsuitable for the task and item to be cut.
• Hold the saw in front of you with a firm grip on the handle.
• Ensure that the saw blade is not touching anything and that the power cable is not in
the way when starting the saw.
• Make sure that the item is clamped tight, and that the saw line is clearly marked.
• Connect the vacuum extractor nozzle to an extractor system where possible.
• Start the saw. Place the soleplate on the item, and let the saw blade touch the saw line.
• Saw, but do not place more pressure on the blade than is necessary. Avoid lateral
pressure on the blade.
14
Fence
Fence Knobs
BASE PLATE SCREWS
LASER
LED work-light
20V ULTRA Jig Saw 2Ah KIT (MH-03-JS-B1-0-1)
Special Notes On Jig Sawing
• Place the soleplate on the item so the saw blade is vertical and correctly positioned in
relation to the saw line without touching it.
• Start the saw and tilt it carefully while supporting it using the soleplate until the blade
touches the item at the saw line.
• Let the blade work through the item, continuing to tip the saw downwards until the
sole is flush to the item and the blade is perpendicular to it. If necessary, drill a hole of
suitable diameter in the item for use as starting point.
- Sawing wood
Check that the item does not contain nails or other metal objects. Always wear a mask.
- Sawing metal
We recommend lubricating the material and saw blade with cutting oil to protect the
tool and avoid overheating. Support the item with wooden blocks on either side.
- Sawing plastic
Make a test cut first to check if the material can tolerate the heat generated by sawing.
Important!
Check all screws on the saw regularly, particularly those that hold the blade. Tighten if
required. Check regularly that the carbon brushes are in a good condition. If the carbon
brushes are worn, they should be replaced.

TROUBLESHOOTING

Problem Possible cause
• Unit will not start • Battery not installed properly
• Battery not charged
• Battery will not • Battery not installed into
charge charger
• Charger not plugged in
• Surrounding air temperature
too hot or cold
15
Possible solution
• Check battery installation
• Check battery charging
requirements
• Insert battery into charger
until red LED appears
• Plug Charger into working outlet.
Refer to "Important Charging
Notes" for derails
• Move charger and tool to
a surrounding air temperature
of above +39.2°F(4°C) or below
104°F(40°C)