Operation - Hart HPSV60 20V Manual Del Operador

ASSEMBLY
ASSEMBLING THE VACUUM
See Figure 1, page 8.
 Switch off unit and remove the battery pack.
Place the vacuum on a flat surface in the upright position.

Slide the handle into the opening at the top of the vacuum

until it clicks.

OPERATION

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
 Household type
To remove the handle:
Insert a small object into the hole on the back of the

handle and press firmly.
Pull the handle up and away from the vacuum

INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 8.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
STARTING/STOPPING THE VACUUM
See Figure 3, page 9.
 T o start the vacuum: press the ON/OFF button.
 T o stop the vacuum: press the ON/OFF button again.
5 – English