Circuit Diagram; Preparation Before Use - Hendi 221204 Manual Del Usuario

Remark: The content of this manual applies for all listed items
GB
unless specified otherwise. The appearance may vary from the
shown illustrations
Spare parts or accessories
(Fig.2 on page 3)
1. Small
2. Medium
3. Large

Circuit diagram

(Fig.3 on page 4)
1. Temperature limiter
2. On / Off switch
3. Power input
4. Capacitor
Exploded diagram with part list
(Fig.4 on page 4)
Part no.
1
2
3
4
5 Stainless Steel Juice Bowl
6 Seal ring 11.8×1.8
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
8
Part name
Outer-cone
Inner-cone
Cone
Pip-filter
Connect shaft
Buckler
Washer12×1.5
Rubber loop
Hollow cylinder
Seal ring 9.5×1.8
Big bearing seat
Motor
Wire holder
Cooler
Spring Washer 6
Nut M6
Motor housing
Cup seat
Switch
Washer 4
Spring Washer 4
Bolt M4×12
Bolt M4×8
Bolt M4×28
Capacitance
28
29
30
31
32
33
34
35
36
37

Preparation before use

• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
Quantity contact the supplier immediately. In this case, do not use the
device.
1
• Clean the accessories and the appliance before use (See == >
1
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
1
• Place the appliance on a horizontal, stable and heat resistant
1
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
1
the future.
1
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
1
a light odor during the first few uses. This is normal and does
1
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
1
Operating instructions
1
• CAUTION! Please make sure the switch is on the "0" position
1
before plug in.
1
• Carefully clean citrus fruits before squeezing them.
• Cut the fruits to be squeezed into two halves.
1
• Place a suitable size of the pressing cone match with the fruit
1
on the appliance.
• Switch on the appliance by turning the switch to the "I" po-
2
sition.
1
• Squeeze the fruit halves.
• Switch off the appliance by turning the switch to the "0" posi-
1
tion after finish operation.
1
Thermal protection
1
This juicer is protected by a built-in thermal cut-out. In the
1
event of overheating, the motor will stop.
1 To reset, follow these steps.
• Set the On / Off switch to "Off", and disconnect the plug
8
• Wait until the motor cools (20-45 minutes), reconnect the
8 plug, then press the On / Off switch again. If the problem
persists, remove the plug from the socket, and contact your
3
supplier.
3
2
1
Capacitance holder
Power cord
Plug
Cord holder
Base board
Foot
Bolt M4×20 with washer
Underlay
Bolt M4 x 12 with washer
Plastic cover
1
1
1
1
1
4
4
1
1
1