Descargar Imprimir esta página

DJI T40 Guía De Usuario página 7

Ocultar thumbs Ver también para T40:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 57
4. Turn on the air circuit breaker of the three-phase AC power supply.
5. Connect the charger to the battery.
• If using Agras T40, connect the charging cable to the air-cooled heat sink before putting the battery into
the heat sink. The charger starts to charge the battery. The four LEDs of the battery blink in sequence while
charging. Remove the battery when the four LEDs turn solid or off and put another battery inside the heat
sink to charge.
• If using Agras T20P, connect the charging cable to the battery directly. The charger starts to charge the
battery. The four LEDs of the battery blink in sequence while charging. Remove the battery when the four
LEDs turn solid or off and connect another battery to charge.
6. When charging is finished, turn off the air circuit breaker before disconnecting the three-phase AC power cable
from the charger.
Connecting to Single-Phase AC Power
1. Connect the two single-phase AC power cables. Connect the single-phase AC power cable (charger) to the
charger and then connect the single-phase AC power cable (power supply) to a power outlet.
• The type of the power outlet may vary depending on the country or region. Choose the appropriate
power outlet accordingly.
• The power outlet should provide at least 16 A of current.
≥16 A
3
2. Connect the charger to the battery following the same method described in the Connecting to Three-Phase AC
Power section.
3. When charging is finished, disconnect the AC power cable from the power outlet and then disconnect the AC
power cable from the charger.
6
1
2

Publicidad

loading

Este manual también es adecuado para:

T20p