Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid causing damage to the thread, DO NOT over-tighten the bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Insert two Wood Dowels (4) into the non-threaded holes on the top of one Leg (C). Position one Side
Mounting Board (F) onto the inserted Wood Dowels (4) on the Leg (C) and attach into place with four
40 mm Bolts (1), four Lock Washers (2) and four Flat Washers (3).
3. Repeat the same procedure with the other Side Mounting Board (F).
Assembly Instructions
DO NOT fully tighten the bolts initially until all the bolts are ready to assemble.
M10 x 30 mm Wood Dowel
4
M8 x 40 mm Bolt
(8 used in this step)
①
Lock Washer
(8 used in this step)
②
Flat Washer
(8 used in this step)
③
(4 used in this step)
④
Publicidad
