Polaris MAXX Manual Del Propietário página 4

Read the complete owner's
manual before you begin installation.
Installation
STEP 1. Prepare the Pool
1. Manually vacuum the pool and make sure the pool filter and pump basket are clean.
2. Turn off the pool filter pump.
3. Close the pool main drain line.
4. Aim the return line fittings down.
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN SERIOUS
INJURY OR DEATH. Ensure that your vacuum suction fittings installed in your pool for connection of
your suction-side pool cleaner are certified as being compliant with applicable safety standards such as
IAPMO SPS 4. Do not block the suction fittings with any part or your body. Do not expose your hair,
loose clothing, jewelry, etc. to any suction outlet fittings or hose ends in the pool/spa.
STEP 2. Assemble Hose Sections
Push and twist the connector on each hose section (g) until they lock into position with clicking sound
(Figure 1). Hose cuffs have three (3) connection positions. Any of the three (3) positions are sufficient
for an air-tight seal.
STEP 3. Connect to a Dedicated Suction Line
1. Twist-lock the male end of the hose (g) into the large end
of the extended 45° elbow (d).
2. Connect elbow to the installed Safety Vac
wall fitting (sold separately).
3. Angle the elbow toward the water surface (Figure 2).
4
WARNING
g
g
Figure 1.
Figure 2.
Hose Sections
g
d
Dedicated Suction
Line Connection