Operating The Control Unit - Klarfit Ease Delux Manual De Instrucciones

EN
28

OPERATING THE CONTROL UNIT

Automatic mode
Press the switch-on button to activate the heat massage pad. Now the
automatic mode starts, which lasts for 10 minutes. The device then
switches off automatically. In this mode, massage level 1 and intensity
level 1 are active.
To deactivate the lumbar pad again, press and hold the power button for
2 seconds.
Mode
Press the MODE button to select one of two available massage modes.
Each time you press the MODE button, the display shows "A1" and "A2"
in succession.
Intensity
Press the INTENSITY button to set 3 available intensity levels. Each
time the INTENSITY button is pressed, the numbers "1-3" appear in the
display.
Time setting
Each massage session lasts a maximum of 10 minutes. Press the
TIME button to set the massage time (5 or 10 minutes).
WARNING
Danger of electrocution! Do not use near water. Do not allow
the unit to get wet. Do not use if the wires are exposed. Make
sure that children do not play with the unit.