Care And Maintenance - TAKATA MIDI I-SIZE PLUS Manual De Instrucciones

Step 3 – Adjust the lap belt
WARNING!
Pull the lap belt down as far as possible, so that the lap
area of your child is protected. If the lap belt runs
across your child's stomach, there is a risk of internal
injuries in the event of an accident.
Ensure that the cushion behind the buckle has not
slipped out of place, so that it no longer protects your
child against the buckle's plastic components.
Step 4 – Tighten the straps
[MIDI_I-SIZE_PLUS_052 a + b] To tighten the straps,
pull the end of the central pull strap forward (not up or
down, and not to the side).
CAUTION!
You can ensure that the belt tension is correct if only one
lap belt of the MIDI I-SIZE PLUS after tightening them.
Step 5 – Check the side crash pads
WARNING!
[MIDI_I-SIZE_PLUS_048 a + b] Always ensure that
Step 6 – Check the size of the seat
WARNING!
[MIDI_I-SIZE_PLUS_008] Check that the top of
your child's head is lower than the top edge of the
adjustable inner padding of the MIDI I-SIZE PLUS. If
the headrest is too low, there is a greater risk of injury
in the case of an accident. As soon as the top of your
child's head reaches or exceeds the top edge of the
adjustable inner padding, when the inner padding is at
its highest point, you should switch to the next size of
child seats, e.g. the MAXI.
Checklist – securing your child:
Please ensure that:
• the height of the adjustable inner padding with the
AIRPADS is adjusted to your child (as described in these
instructions).
• the lap belt does not run over your child's stomach.
• the buckle and tongues are correctly secured.
•
• the top of your child's head is lower than the top
edge of the adjustable inner padding of the
MIDI I-SIZE PLUS.
20
Removing your child
[MIDI_I-SIZE_PLUS_053 a - d] Before you can lift
your child out of the MIDI I-SIZE PLUS, you must
loosen the straps and open the buckle. To do this,
follow the instructions in Section 3 – Basic instruc-
tions (Loosening the straps and opening the buckle).
You can then lift your child from the MIDI I-SIZE
PLUS.
6. CARE AND
MAINTENANCE
Removing the covers
Step 1 – Remove the inner padding
Open the shoulder pads' Velcro and take the shoulder
pads off the shoulder belts. Remove the inner padding
position. Then pull the lower pouch on the rear of the
padding down and away from the back plate. Follo-
wing this, pull the inner padding up and away from
the back plate.
Step 2 – Remove the side crash pads (AIRPADS)
WARNING!
The AIRPADS in the adjustable inner padding and in
the seat reducers for babies are not washable and must
be removed from the adjustable inner padding and
from the seat reducer for babies before washing.
[MIDI_I-SIZE_PLUS_054] To do this, lie the inner
padding or the seat reducer for babies down, with its
front side on an even surface. You can then reach into
the back through the opening of the cover. Remove the
AIRPADS in the side wings of the padding and in the
side wings (shoulders and head) of the seat reducer for
babies, as shown in the illustration.
Step 3 – Open the belt buckle and remove the lap pads
[MIDI_I-SIZE_PLUS_022 a] Open the buckle and pull
the tongues out. Open the lap pads' Velcro and take the
lap pads off the lap belts.
Step 4 – Remove the cover
After removing the inner padding, return the back plate
to its lowest position. Loosen the bungees and fold out
the plastic components around the edge of the cover.
Open the Velcro at the inner sides of the cover, so that
you can take off the cover of the shell. Remove the straps
from the cover and thread the buckle out of the cover.