Descargar Imprimir esta página

RIB FIT SIX Manual Del Usuario página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

FIT SIX
G
B
code ACG8049
BS EN ISO 13849-1:2015 PL»c» CAT.2
(under the condition that the door control system monitors the sensor at least once per
door cycle BS EN12453:2017 5.1.2)
CPL1504
DAC29X13
BC00425
CPL1507
CVA2308
CPL1501
BC00424
CPL1503
CVA2308
CPL1502
CPL1501
USE
The FIT SIX photocells are an active safety for all kinds of power-operated opening
systems.
They can be fixed to vertical supports in iron or other smooth materials.
The box ACG8051 makes them easy to fit to uneven brick surfaces.
OPTIONAL ACG8051
NO
REFERENCE LEGISLATION FOR POWER-OPERATED DOORS AND GATES
Installers must make sure that the photocells are only installed together with another
primary safety device, as specified in point 5.1.3. of standard BS EN 12453:2017.
RIB DECLINES ALL LIABILITY FOR DAMAGE CAUSED BY IMPROPER, INCORRECT OR
IRRESPONSIBLE USE.
35
CPL1506
DAS35X13
CPL1505
TX
CPL1506
DAS35X13
CPL1505
DAC29X13
CPL1504
RX
OK
ASSEMBLY
Fit the boxes to the pillars or supports at a height of about 40-60 cm from the ground
and at a maximum distance of 10 cm from the entrapment or crushing area or
immediately beyond any protruding edges.
Install the receiver in a shaded area or where horizontal rays of sunlight cannot reach it.
Always install the photocells at the same height and make sure they are well aligned.
ELECTRIC CABLE FIXING
70
Use H05RN-F cables, with a minimum section of 0,75 mm
If you exceed the distance of 15 m between photocells and control panel, the wire section
must be increased to 1 mm
6
CVA2307
DTC3X12S
ASSEMBLY
If you wish to direct the infrared beam, you must remove the supports on the container
and orient the circuit as indicated below.
CVA2307
DTC3X12S
CONNECTIONS
The FIT SIX photocells can be connected in different ways depending on the type of
power supply provided by the control boards.
FIT SIX photocells are setted in factory for 24V power supply.
It is possible to power them at 12V by welding a jumper on their cards.
.
2
.
2
1
2
1
2
D+ D-
D+
D-
A* A
A* A
Scarica questo manuale sul tuo cellulare
Téléchargez ce manuel sur votre mobile
Download this manual on your mobile
Laden Sie dieses Handbuch auf Ihr Handy herunter
Descarga este manual en tu móvil
3
4
5
NO
C
NC

Publicidad

loading

Este manual también es adecuado para:

Acg8049