Standard Accessories - HIKOKI G 3612DVE Instrucciones De Manejo

Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
n
Rated speed
n
No-load rotation speed
0
min- Revolution or reciprocations per minute
1
A Auto mode
D Wheel outer diameter
d Wheel hole diameter
t Wheel thickness
Peripheral speed
Weight*
(According to EPTA-Procedure 01/2014)
kg
Switching ON
Switching OFF
Disconnect the battery
Lock
Unlock
Auto mode switch
Lighting mode switch
Always ON (turn off after 60 minutes)
Light only SW-ON
Always OFF
Warning
* Depending on attached battery. The heaviest weight is
measured with BSL36B18 (sold separately).
Also, the weight includes the wheel guard, side handle,
wheel washer, and wheel nut.
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 276.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various types of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means of
a cutting torch.
○ Grinding of synthetic resins, slate, brick, marble, etc.
SPECIFICATIONS
1. Power tool
The specifi cations of this machine are listed in the Table on
page 274.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Electronic control
○ Soft start
Reduces recoil against the operator by managing the
number of rotations during startup.
○ Kickback Protection
The kickback protection feature cuts off the power to
the motor and stops the power tool in the event of a
sudden drop in the rotational speed of the wheel during
operation (for example, if the wheel locks during cutting
operation, etc.).
○ Overload protection
While working, if a load exceeding a certain level is
applied, or if the grinding disc is stopped for a certain
amount of time, the motor will be stopped to protect the
tool and for safety.
Turn off the switch once, then turn it on again to start up
the tool.
13
English