Publicidad
Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
10.8
Use of cabinet
IT
Lighting
FR
The cabinet lighting is controlled by a switch on
the bottom right of the cabinet.
EN
EN
Thermostat/thermometer
A
remote
DE
positioned on the bottom right of the cabinet to
control the temperature.
ES
The remote thermostat displays the existing
temperature inside the housing and the
PT
temperature is controlled using the dedicated
buttons.
Configuration
display shelves
To ensure the correct performance that the
cabinet was designed for, shelves must be
arranged inside the cabinet according to the
set-up described below. (tables "Chart III",
"Chart IV" to pg. "17").
By varying the coupling position of the shelves
with the rear uprights of the counter, 4 different
inclinations ("Fig. 18").
Only for open model
L
Using night covers or night curtains, if
any are installed, during closing hours.
("Fig. 15").
N°DOC. UM000460 REV. "F" - 24/03/22
thermostat/thermometer
and
inclination
PROFILE
Epta Spa - Via Mecenate, 86 - 20138 Milano (MI) ITALIA
Tel. 02/55403211 Telefax 02/55401023
10.9
Cleaning and ordinary
maintenance
Good visibility in the intervention area is
recommended, possibly using an additional
light source.
is
Cleaning the cabinet
Only use water at a maximum temperature of
65°C and household soap or neutral detergent
diluted in water.
For glass surfaces use only products for cleaning
glass. It is recommended to avoid the use of
water since it may deposit limestone on the
surface of the glass.
of
the
Never use:
• Abrasive sponges
• Flammable or abrasive products such as
alcohol, acetone or solvents
• Detergents
surfactants, lemon or vinegar (acetic acid)
F
Do not wash or clean the top part of the
cabinet with water or liquids.
Clean all the external parts of the cabinet ONCE
A WEEK.
Clean all the internal parts of the cabinet ONCE
A MONTH, following the instructions below:
• Disconnect the power supply to the cabinet
using the wall-mounted main switch-
disconnector ("Fig. 22").
• Empty the cabinet, storing the goods in
cold rooms or refrigerators to maintain the
preservation temperature.
• Wait for the inside of the cabinet to have
reached the ambient temperature and
then clean
• After carefully checking that the inside of
the cabinet is completely dry, restart the
appliance by re-energising the cabinet.
• After a couple of hours, load the goods
again.
19/23
that
contain
non-ionic
Publicidad
