Other Information - Sharp DR-430 Manual Del Usuario

10
The current setting will have an asterisk (*) in the
display. Press to select.
Similarly, use
for the backlight brightness for the <Dim level>
and <On level>. There are 3 options available:
<High>, <Medium>, and <Low>.
Display language
To change the display language, long press
. Use to scroll and select <System> /
<Language>. Use
your preferred language. There are 7 options
available: English, French, German, Italian,
Spanish, Polish, and Dutch. An asterisk (*) will be
displayed next to the current language setting.

Other information

Software version
To check the software version of your radio, long
press . Use
<System> / <SW Version>. The software version
will be displayed.
Factory reset
You can reset your radio to restore it to the
original factory settings.
Note: If you reset your radio, your stored presets
will be deleted and any connected Bluetooth
device will be unpaired.
Long press . Use
<System> / <Factory reset>. <Factory Reset?
<No> Yes> will be displayed. Use
scroll and select <Yes>. <Restarting...> will be
displayed. After a few seconds, the display will
change to <SHARP sharpconsumer.eu> and will
then go to standby mode.
to change the settings
to scroll and select
to scroll and select
to scroll and select
to
Troubleshooting
If there is no sound or power:
• Adjust the volume.
• Check that the power cable is connected and
that the radio is not in standby mode.
If the radio reception is poor:
• Make sure that you have fully extended the
telescopic aerial (preferably vertically).
• Rescan for radio stations, see sections 'Scanning
for DAB stations' and/or 'Tune to an FM station'
as appropriate.
• Try moving your radio to another location to
see if the reception improves.
• Check that you do not have other electrical
equipment close to your radio. This may cause
interference.
If you are unable to pair with a Bluetooth
device:
• Check that you are in Bluetooth mode.
• Ensure that you are within 10 metres of the
radio for Bluetooth functionality.
• Move the radio and Bluetooth device away from
other Bluetooth devices/electrical equipment.
• If possible, turn off other nearby Bluetooth
devices or disable their Bluetooth functionality.
If the function buttons do not respond:
• Short press
.
• Switch off the power supply to the unit, wait 10
seconds and reconnect power supply.
Note: All your settings, including the radio station
list, connected Bluetooth devices and any presets
will be deleted when a factory reset is carried out.