Vertical Ironing; General Maintenance - POLTI Vaporella INSTANT VI50.50 Manual De Instrucciones

penetrates further into the fabric, speeding
up and improving the ironing. With this mode,
the iron will automatically begin alternating,
dispensing steam for 1 second and then stop-
ping for 1 second.
To deactivate this function, press the
ton again, or press the steam button. To reac-
tivate, repeat the procedure from the begin-
ning.
ATTENTION: Do not rest the iron on the
iron rest with the STEAM-PULSE FUNCTION
activated.
5.

VERTICAL IRONING

The iron may be used in the vertical position
to remove creases from fabrics and/or to re-
fresh fibres, eliminating any residual odours.
Hold the iron in a vertical position, press the
steam button under the grip of the iron (7),
and where possible, depending on the type of
fabric, touch it lightly with the plate.
6. AUTOMATIC SHUT-DOWN
FUNCTION
Automatic shut-down will activate if the appli-
ance is unused for 10 minutes, and this will be
indicated by the light (9). To reactivate the
appliance, press the steam button under the
grip of the iron (7).
7. OUT OF WATER
The water level is always visible from the tank.
When the water inside the tank has been
used up, steam will stop coming out. To re-
sume use, simply switch off the appliance and
fill the tank with water (1) up to the MAX line
on the tank. This step must always be carried
out with the power cord unplugged from the
mains.
Press and hold the button until steam is
comes out.
8. REPLACEMENT OF THE
LIMESCALE FILTER
The light on the iron's display (10) indicates
that the limescale filter needs replacing.
To replace it, proceed as follows:
- Turn off the appliance by pressing the key
with the symbol (3) and unplug it from
the mains electricity.
- Remove the filter (11) and replace it with a
new, original one (12).
- Plug it into the mains electricity (2).
- Switch on the appliance by pressing the key
with the symbol (3).
- Hold the
to activate the Reset function, which enables
the system to fill the new filter and continu-
ation of ironing.
Replace the filter every time the
but-
comes on (10).
Continuing to iron and postponing replace-
ment of the filter will compromise the reliabil-
ity and life of the product.

9. GENERAL MAINTENANCE

Before carrying out any maintenance on
the device, always unplug it from the mains
electricity, making sure that the product has
cooled down before proceeding.
To clean the body of the appliance, only use
a damp cloth.
Do not use detergents of any kind.
Clean the plate when completely cool with a
damp cloth or non-abrasive sponge.
10. STORAGE
Hold the iron above the iron rest, inserting the
back first (14) and then the point, locking it
in place with the locking switch
lease the iron, move the locking switch
Turn off the appliance by pressing the key
with the symbol (3) and unplug it from the
mains electricity. Insert the iron cord in the
holder on the left (17-A) and the power cord in
the holder on the right of the appliance (17-B).
Wait for the appliance to cool completely be-
fore replacing it.
13
and keys (13) for 5 seconds
(15). To re-
light
(16).