Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Warnings and safety instructions
Package contents
Description of parts
Getting started
•
Take the device out of the box.
•
Remove all packaging materials from the product.
•
Place the packaging materials in the box or dispose of them safely according to the
recycling instructions on the packaging of the device.
Warnings and safety instructions
You must read and understand all instructions before using this device. In the event of damage
due to failure to follow the instructions, the warranty will not apply.
1. Never remove the casing from this device.
2. Never place this device on top of other electrical equipment.
3. Protect the power cord from being walked on or pinched, particularly at
plugs, sockets and the point where they come out from the device. Check
that the supply voltage corresponds to the voltage shown on the plate on
the back of the device. When disconnecting the mains plug, always remove
the plug from the socket. Never pull on the cord. Before plugging into the
power outlet, make sure you have made all the other connections.
4. Use only equipment/accessories recommended by the manufacturer.
5.
Leave all repairs to the device to qualified repairers. Repair is necessary when the device
has been damaged in any way, including:
- if the power cord is damaged;
- in the event of a liquid spill or objects being inserted into the device;
- if the device is exposed to rain or humidity;
- if the device does not operate normally;
- or if the device has been dropped.
6.
The type plate is located on the bottom of the device.
7.
Never block the ventilation holes.
8.
Make sure you have sufficient, stable space around the device for ventilation.
9.
This device should be used in a temperate environment, away from direct sunlight, naked
flames or heat, heaters, stoves or any other device (including amplifiers) that generate
heat. Do not install it near heat sources.
10. The batteries (battery pack or batteries installed) must not be exposed to excessive heat,
such as direct sunlight, fire, etc.
11. Unplug the device before cleaning it. Do not lubricate any part of this device. Clean it with
a soft cloth. Do not use abrasives or aggressive cleaners.
7
Plugging in the connector in/out
7
Technical specifications
8
Care for the environment
8
Declaration of conformity
- EN 7 -
9
9
9
9
Publicidad
