Start Up - Truper SOP-T12 Manual De Instrucciones

Start up

• Secure the workpiece to be drilled in the walrus clamp
(A).
C
• Insert the required drill bit into the drill chuck of the drill.
• Lower the lever until the drill hole is drilled.
• To drill a hole of a certain depth:
1. Lower the lever so that the drill bit contacts the
B
workpiece.
2. Note the value indicated on the depth scale (B).
3. Advance the drill bit into the workpiece until the pointer
on the scale reaches the required depth.
4. At this point secure the measurement with the depth
adjustment knob (C).
A
8
ENGLISH