MESTIC MS-125 Instrucciones De Uso página 11

To safely clean the filters, the filter can be shaken above a waste bin. In case of stubborn dirt, the filter can be cleaned under the tap. Before
replacing the filters, they must be completely dry. Do not under any circumstances use a hard brush, this can irreparably damage the filters.
Replacing the filters
1. Place the filter housing back into the container by aligning the triangle mark (on the top) and the line marking on the side of the container.
2. Now put the filters back in place and close with the cover. Align it in the same way as the filter housing until it clicks into place.
3. Now reassemble the motor housing and the collector by clicking them together.
4. Now put the exhaust filter back in place and click the grill cover back on.
Important while cleaning
1. The filters should be cleaned regularly to ensure the best performance of the device and to avoid overheating.
2. Cleaning is best done after you have emptied the container.
3. Never operate the appliance when the filters are still wet or when no filters are installed.
4. Wash the filters in medium hot water with a mild, non-aggressive detergent. Then rinse them with cold water and let them dry completely.
5. Clean the filter housing with medium hot water and let it dry completely.
6. Using wet filters can create dangerous situations and cause irreparable damage to you and the device.
7. Do not dry the filters with a hair dryer.
8. Do not clean any parts of the vacuum cleaner or filters with fuel or other highly flammable products.
9. Only clean the vacuum cleaner itself on the outside, using only a damp cloth and a mild detergent.
10. After cleaning, dry off the moisture from the vacuum cleaner, parts and accessories with a dry cloth.
11. Do not put accessories or parts in a dishwasher.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means that this pro-
duct must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its
impact on the environment. For further information, please contact your local or regional authorities. Electronic products
not included in the selective sorting process are potentially dangerous for the environment and human heath due to the
presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MS-120, applies all basic requirements and other relevant
regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive
(2014/35/EU). If you require a full declaration of conformity, you can contact the adress listed on the backside of this
manual
ENGLISH