Trust START-LINE AWST-9000 Manual Del Usuario página 7

After choosing the desired Turn-off time, press and
hold the ON and OFF button simultaneously again for
3 seconds, until the LED flashes quickly to confirm the
setting.
Optional: Adjust the dimming range
A
Press the ON button to turn on the receiver.
B
Press the ON button again to activate the dimming
mode. The light will dim slowly in a cycle from high
brightness to low brightness.
C
Press the ON key for the third time to lock the desired
brightness.
Only with the ACC-250-LD and ACM-250-LD it is
possible to dim the receivers by holding down the ON
button to increase the brightness or holding down the OFF
button to decrease the brightness.
Press the ON button twice quickly to immediately set
a dimmer to 100% brightness.
Press the OFF button twice quickly to immediately switch
a dimmer to the lowest brightness.
Optional: Create a double wall switch
To turn the AWST-9000 into a double wall switch, carefully
remove the button with a flat screwdriver.
Click the supplied push buttons for a double wall switch on
the AWST-9000.
The two push buttons can be used as two separate
channels to switch lamps / devices.
AWST-9000 WIRELESS WALL SWITCH
Optional: Unpair a Trust Smart Home receiver
Put the receiver in the learning mode (see the manual
of the receiver for information on how to activate the
learning mode).
When the receiver is in learning mode, send an OFF signal
with the wall switch. The LED on the wall switch flashes
2x red.
EN
7