Publicidad
TABLE OF CONTENTS
FIG. 3
Warning and precautions............................................. GB 1
Over view .................................................................GB 2
Operating Instructions .................................................GB 3
Shade Levels/ Welding applications................................GB 4
Specification / Technical Data........................................GB 5
STIL
TILIZAR
Replacing External Protective plate................................. GB 5
Headgear removal/ Replacement ................................... G B 5
Replacing inner protective plate.....................................GB 5
Replacement parts .....................................................GB 6
Maintenance and cleaning ...........................................GB 7
FIG. 4
Storage.....................................................................GB 7
Customer service........................................................GB 7
Warranty...................................................................GB 7
Warning !
This helmet provides limited protection from minor and incidental impact hazards, and no protection
while in the raised position. Do not rely on this welding helmet as your primary protection from impact
or splash hazards. For your protection, read these welding helmet and ADF instructions completely
before using. Failure to follow all of these instructions can result in serious and permanent injury, vision
loss or burns.
USA IMPACT RESISTANT SAFETY SPECTACLES OR GOGGLES MUST BE WORN AT ALL TIMES
FIG. 5
WHEN USING THIS HELMET.
Clear polycarbonate protective plates must be installed on both the inside and outside of the auto-dark-
ening filter (ADF) before use. Failure to use protective plates can result in irreparable damage to the
ADF and may cause serious and permanent injury, vision loss or burns. Damage to the lens from fail-
ure to install clear plates will void the warranty. The protective cover plates of this helmet only provide
protection against splatters and surface damage to the lens, NOT against severe impact hazards, such
as fragmented grinding wheels or abrasive discs, explosive devices or corrosive liquids.
BEFORE WELDING
• Ensure that the helmet is correctly assembled and that it completely blocks any accidental light. In the
front, light may enter the helmet only through the viewing area of the autodarkening welding filter.
• Adjust the headgear to maximize comfort and field of vision with the flexi-seal providing a good seal to
the face, especially reaching down to the chin.
• Check the prescribed shade level, light sensitivity, opening time delay for your welding application and
adjust your ADF accordingly (see the table with recommended shade levels).
GB 2
Rebel Goggle User Manual.indd 3-4
24/08/2020 09:05
Publicidad
