Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A CONFINED
AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death could occur. Always
operate the inflator in a well-ventilated area free of combustible materials, gasoline, or solvent
vapors. Always set parking/emergency brake and ensure vehicle is in Park (or neutral if equipped
with manual transmission.)
• Do not attempt to disassemble inflator.
• No user serviceable parts inside. The only user serviceable part is replaceable fuse.
• Keep inflator out of reach of children.
• Ensure air hose chuck touches the core of the valve stem for proper inflation.
• DO NOT use inflator continuously for more than 6 minutes. Allow unit to cool approximately 20 minutes
between uses. Do not leave inflator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inflate.
• Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful not to inflate
items beyond their capacity.
• While operating, never block the inflator input or output.
TECH SPECS
TIRE INFLATION TIME
CFM (LPM)
DIAL GAUGE
POWER SOURCE
REPLACEABLE FUSE
120V POWER CORD LENGTH
AIR HOSE LENGTH
* (0-35 PSI, Standard Tire: P195/65 R15)
INFLATE TIRES
1
1. Make sure the power cord is
1. Make sure the power cord is plugged into a 120 volt wall power outlet.
plugged into a 120 volt wall
2. Place hose connector on air valve stem and push down thumb latch to lock onto valve.
power outlet.
3. Press power button on inflator to turn on. Inflate tire to manufacturer's recommended
air pressure. Correct tire pressure can be found in vehicle owner's manual or on driver's
side door jamb. When desired pressure is reached, turn off inflator.
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS
EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER
VENTILATION.
2
2. Place hose connector on air
valve stem and push down
thumb latch to lock onto valve.
show #2 as being put onto the
valve stem and the pushing
the lever down to lock(arrow?)
6 min*
0.75 CFM (21.2 LPM) @ 0 PSI
PSI 0-60, BAR 0-4
120V plug into wall outlet
2A 250V 5mm x 20mm
6 ft. (1.82 m)
20 ft. (6.1 m)
3
3.Press power button on
inflator to turn on.
Publicidad
