Publicidad
Idiomas disponibles
Idiomas disponibles
English
SPECIFICATIONS
1. Cordless Disc Grinder
Model
Motor
Rated Speed
Wheel Size:
external dia.
thickness
hole dia.
Peripheral speed
Type
Battery
Voltage
Weight
2. Battery Charger
Model
Input power source
Charging time
(At a temperature of 68°F (20°C))
Charging voltage
Charging current
Weight
NOTE: The charging time may vary according to ambient temperature and power source voltage.
Electric control
○ Soft-start
○ Overload protection
While working, if a load exceeding a certain level is
applied, or if the grinding disc is stopped for a certain
amount of time, the motor will be stopped to protect
the tool and for safety.
Turn off the switch once, then turn it on again to start
up the tool.
○ Rotation recovery control function
While working, if the tool is pressed too forcefully
against the surface and the motor stops, if you lift up
the tool and lighten the load, rotation will resume.
Depending on the grinding disc used and the working
conditions, the rotation recovery control may be
stopped by overload protection.
12
G1812DF
DC brushless motor
Transmission mode : 8,000 /min
Auto mode : 5,500 /min
4-1/2" (115 mm)
1/4" (6 mm)
7/8" (22.23 mm)
80 m/s
Li-ion battery Model BSL1850MA
DC 18 V
6.4 lbs (2.9 kg) (BSL1850MA attached)
7.3 lbs (3.3 kg) (BSL36B18 attached)
UC18YSL3
Single phase: AC 120 V 60 Hz
BSL1850MA: Approx. 32 min
DC 14.4 V–18 V
DC 8.0 A
1.3 lbs. (0.6 kg)
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in
a few minutes.
After that you can use it again.
○ Restart prevention function
When the power is still switched on, the tool will not
restart when a battery is installed. This function can
be canceled once the tool is switched off .
○ Brake function
Brake activates when the switch is off.
Publicidad
