Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised STANLEY FATMAX Service
Centre in order to avoid a hazard.
Description
This tool includes some or all of the following features.
1. Variable speed trigger
2. Boost button
3. Handle
4. Upper blower tube
5. Lower blower tube
6. Battery
7. Battery release button
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger will
begin to charge automatically when the cell temperature
warms up or cools down.
Note: To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before first use.
Plug the charger (8) into an appropriate outlet before
u
inserting battery pack (6).
The green charging light (8a) will blink continuously
u
indicating that the charging process has started.
The completion of charge will be indicated by the green
u
charging light (8a) remaining ON continuously. The battery
pack (6) is fully charged and may be removed and used at
this time or left in the charger (8).
Charge discharged batteries within 1 week. Battery life will
u
be greatly diminished if stored in a discharged state.
Charger LED Modes
Charging:
Green LED Intermittent
10
(Original instructions)
Fully Charged:
Green LED Solid
Hot/Cold Pack Delay:
Green LED Intermittent
Red LED Solid
Note: The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
Note: This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold,
it automatically starts a Hot/Cold Pack Delay, the green LED
(8a) will flash intermittently, while the red LED (8b) will remain
on continuously, suspending charging until the battery has
reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This
feature ensures maximum battery life.
Battery state of charge indicator (Fig. B)
The battery includes a state of charge indicator to quickly
determine the extent of battery life as shown in Fig. B. By
pressing the state of charge button (6a) you can easily view
the charge remaining in the battery as illustrated in Fig. B.
Blow Tube Assembly (Fig. C)
Caution:
Blow tubes must be assembled before use.
u
Never operate without the upper tube assembled to the
u
blower and the lower tube assembled to the upper tube.
In the interest of safety, it is not intended for the tubes to
u
be separated once assembled.
To Assemble Blower Tubes
Align the upper tube (4) to the blower and the lower tube
u
(5) to the upper tube as shown in Fig. C.
Publicidad
