Operation Instructions; Turbo Mode - Ohyama WOOZOO AP45-M Manual De Usuario

K

Operation instructions

Press operation OFF/ON button
• The operation will start with the set mode before
stopping operation.
• After plugging out the power code or undergoing
power failure, turn on the power to start the
operation in automatic operation mode.
● As the sensor has high
sensitivity, if an ultrasonic
humidifier or a spray is used
Caution nearby, the sensor may react,
without visible mists.
Select the operation mode
• Press the (operation mode)
the mode.
Automatic operation
Selecting the (automatic operation)
automatically change the air flow volume based on
the density that the sensor detects.
Silent , Normal
Selecting (silent
will perform the continuous operation regardless of
the sensor.
button to change
will
, Strong
, normal , strong )
12

■ Turbo mode

When the indoor air was polluted, the air purifier will
clean the polluted air in the strong mode for a short
period of time.
• Press the (turbo)
operation. The (turbo)
Light up
• It will perform the turbo operation for about 10
minutes.
• To end the turbo operation, press the (turbo)
button or (operation mode)
• The operation will start with the set mode before
the turbo operation.
※ Opening the flap of air outlet during the turbo
operation is recommended.
■ To stop the operation
• Press the (operation OFF/ON)
operation, the operation will stop with beep sounds.
■ Change the brightness
• Press the (change brightness) button to
change the brightness of the backlight. Every time
the button is pressed, the backlight's brightness will
be changed as below.
→
100%→50%→10%→Light off
※ Stop the operation to turn off the backlight.
AP45-M
button to perform the turbo
lamp will light up.
button.
button during