Ticor Geyser GA6 Instrucciones De Instalación

F a u c e t s b y
R
These instructions are a reference only; installation should be performed by a qualified professional in accordance with local law.
• Installation requires 1 ¼" hole in countertop or sink
• Maximum countertop thickness: 2"
• For use with 120V AC only
Countertop
1
Remove gasket, metal washer, and both plastic
nuts from switch body. Seat the switch body into
the 1 ¼" hole. Thread the rubber gasket, then
the metal washer, then the large plastic nut back
onto the switch body. Hand tighten only.
3
Hand tighten both nuts to secure the air tubing.
Use included wood screws or appropriate
fasteners to mount the power module in
desired location.
Air Switch Installation Instructions
Model GA6 / GA10
• Do not allow Air Switch Control Box to be exposed to liquid
or moisture
• Top outlet is switched. Bottom outlet is constant power.
2
Remove the small plastic nuts from the air switch
and the control box. Push the ends of the air
tubing through the small plastic nuts. Firmly press
one end of the air tubing into the Air Switch, and
the other into the Air Switch Control Box.
4
Caution! Garbage disposal may
!
turn on when you proceed to step
4. Keep garbage disposal area
clear. If it turns on, push the air
switch button to turn it off.
Plug the garbage disposal into the Air Switch
Control Box using the top outlet. Plug the Air
Switch Control Box into the wall outlet.
Garbage Disposal
Power Cord
120V AC
Wall Outlet