Copy Cutting - Festool OF 1400 EQ-F Instrucciones De Uso Originales

English
6
6-8
6-7
6-6
6-5
Fine adjuster
The fine adjuster (available as an accesso­
ry, [7-5]) can be used to precisely adjust dis­
tance X.
► Install the fine adjuster [7-5] on the guide
rods between the power tool and the guide
rail adapter [7-4].
► Insert the adjusting wheel [7-2] into the
guide rail adapter, as shown in the fig­
ure [7].
► Screw the adjusting wheel [7-2] into the
nuts of the fine adjuster.
To adjust distance X:
► Open the rotary knob [7-1] for the guide rail
adapter and close the rotary knob [7-3] for
the fine adjuster.
► Adjust to required distance X by turning the
adjusting wheel [7-2].
► Close the rotary knob [7-1] for the guide
rail adapter.
14
7
6-1
6-2
6-3
6-4
9.4
A copying ring or the copying device is used to
exactly reproduce existing workpieces (acces­
sories).
Copying ring
When choosing the size of the copying ring, en­
sure that the cutter being used fits through its
opening.
Excess Y (figure [9]) of the workpiece to the
template is calculated as follows:
Y = (copying ring diameter - cutter diameter)/2
► Attach the copying ring [8-1] to the router
table: Insert the two tenons [8-2] into the
recesses [8-3].
► To remove the copying ring: Press the two
buttons [1-16] inwards at the same time.
7-1 7-2

Copy cutting

7-3
7-4
7-5