Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the Oven Knob by pulling it free from the
appliance. You may have to wiggle it slightly as you
pull.
2. Locate the replacement Oven Knob. Align the notch
on the Oven Knob stem with the notch on the inside
of the Oven Mode Selector and push as far as
possible so it fits snugly.
It's a good idea to wipe the control panel after each use. Clean with mild soap and water, rinse with clean
water and polish dry with a soft cloth. Do not use abrasive cleansers, strong liquid cleansers, plastic
scouring pads or oven cleaners on the control panel because they will damage the finish. For easier
cleaning, the control knobs may be removed by pulling them directly outwards once the knobs are in the
OFF position. Do not pull knobs up or down or hang objects on them. This can damage the gas valve
shaft. See the Surface Burner section of your Owner's Manual for a detailed view of these knobs. The
knobs can be washed by hand with soap and water. When removing the burner knobs, remember their
location. The knobs are not interchangeable, these knobs must be placed in the same location after
cleaning. See the Surface Burner section of your Owner's Manual for a detailed view of these knobs. To
replace knobs after cleaning, align the bottom of the knob with the matching clip orientation to the shaft
inside the bezel. Push knob until completely seated.
Use a soft, nonabrasive cloth to clean the inside of the bezel. Do not remove diffuser film. Do not expose
to moisture or it will damage lighting electronics. NOTE: The Mini Knob is not removable.
2
IMPORTANT!
Oven Mode
Selector
Knob Locating
Notch Inside
Mode Selector
31-2000917 Rev. 1
Publicidad
