Publicidad
Idiomas disponibles
Idiomas disponibles
LITTLE BASTARD 2.N
1.
2.
3.
4.
5.
THE VU METER
The VU meter provided on the front panel gives you a visual display of the output of
the amp as its being played. This can be used to ensure clean headroom or to dial in
something a little more aggressive....
1. INSTRUMENT INPUT
There are two instrument inputs, with two sensitivity options. The high sensitivity
toggle is a high impedance toggle to suit passive bass instruments. The Low
sensitivity toggle has an impedance to accurately match the signal from active bass
instruments i.e. those with a built in battery powered pre-amp.
USER GUIDE
VU
6. 7.
8.
LITTLE BASTARD 2.N
2. EFFECTS SEND/RETURN
A tube driven and recovered effects loop is provided, this is situated between the pre-
amplifier and power amplifier, ahead of the master volume. The signal level is suitable
for driving a wide range of effects pedals, the level present being entirely dependent on
the level of pre-gain being used. Only effects should be used in this loop.
3. GAIN TRIM
This works as a gain control from crystal clear tones through to full bore rich harmonic
distortion... A little can go a long way...
4. VOLUME
The output control adjusts the overall level of the amplifier. Adjust this for your preferred
overall stage playing volume.
5. 4 BAND EQ
This consists of treble, hi-mid, low-mid and bass controls with a vastly enhanced range
of over 40dB at full output.
6. CLIP
This is to indicate when clipping occurs on the output signal of the Two notes DynIR
output to maintain a clear representation of the DynIR.
7. OUTPUT LEVEL
This is to set the output volume of the Two notes DynIR output DI on the rear of the amp.
8. PRE-SET
Select from 6 available on board official Ashdown Two notes DynIR impulse response
cabinets designed by us for you. See table *T.1 for list.
USER GUIDE
Publicidad
