Publicidad
Idiomas disponibles
Idiomas disponibles
GTB18V-45 with Optional GMA22 Operating Instructions
Auto-Feed Attachment
WARNING
pinch point area. When operating auto-
feed attachment consider where your
hand is located. If it is within a pinch
point, strongly consider an alternative
position. Injuries occur when hands or
fingers are between moving and
stationary parts during the pinching
movement.
Adjusting for Screw Length
1. The auto-feed attachment must be
adjusted to match length of screw
being used.
2. Depress adjustment button on side
of auto-feed attachment (Fig. 3)
(17).
3. Slide self-feed mechanism forward
or backwards to align arrow on the
sliding
corresponding length printed onto
the auto-feed attachment (Fig. 3).
4. Allow depressed pin to snap back
into place by means of spring force.
Depth Adjustment
Your driver will continue to drive as long
as enough pressure is applied to the bit
to keep the clutch engaged. The auto-
feed attachment is capable of
preventing further pressure on the bit.
Driving then stops regardless of the
pressure continued by the operator.
1. Turn the thumbwheel (Fig. 4) (18)
on the auto-feed attachment
downward to increase the depth the
screw will be driven.
2. Turn the thumbwheel on the auto-
feed attachment upward to decrease
the depth the screw will be driven.
3. The selected depth is indicated
symbolically on the scale next to the
thumbwheel (Fig. 4) (19).
Never place any part
of your body in a
portion
with
Driving Screws
Always work at a right angle to the work
piece to ensure the Auto-Feed
mechanism is able to operate properly.
Failure to do so may cause the Auto-
Feed mechanism to jam or slip off the
screw head.
1. Depress trigger switch to engage the
tool.
2. Set the work contact element on the
auto-feed attachment on the spot
where the screw is to be driven.
3. Apply uniform pressure to the tool in
the direction of the workpiece until
the screw is driven in.
4. By
disengaging tool from driven screw,
the next screw is loaded
Screws already driven cannot be
removed or retightened with the auto-
feed attachment. To remove or tighten
screw, remove auto-feed attachment
the
and use tool without the attachment.
Capacities
Collated screws 1" to 2-1/8" in length, 3/8" max
head diameter and 3/16" max shank diameter.
-15-
releasing
pressure
and
Publicidad
