Publicidad
Idiomas disponibles
Idiomas disponibles
Cordless Iron Use instructions
Filling the water tank
Unplug the power cord from the power outlet before filling the water tank.
Keep the iron in a horizontal position.
Slowly pour the water through the appropriate hole, using the supplied measuring cup.
Be careful not to overfill the tank (see the mark), to prevent the water from escaping.
Note: the iron is designed for use with tap water, however, if the water is very hard, it is advisable to use
a mixture of distilled water and tap water.
It is advisable to empty the water tank after each use, in order to avoid the formation of limescale, mold and bad
odors. It is recommended to allow the iron to cool for a few minutes before emptying the tank.
Temperature selection
Always check the label with the ironing instructions on the article to be ironed and follow them.
Turn the thermostat knob to set the desired temperature, following the legend below.
SYMBOL
FABRIC
Do not iron
Synthetic, Nylon, Acryilic, Rayon
Wool, Silk
Cotton, Flax
Steam ironing
While heating, set the steam button to zero «0»
Position the iron in a vertical position and set the temperature control to minimum.
Insert the plug into the wall socket, then turn the temperature control to maximum. The temperature control light
will switch on, indicating that the iron is heating up.
When the light switch off, the set temperature has been reached and the iron is ready for use.
During ironing, the light will turn on and off automatically as the thermostat maintains the set temperature (it is
still possible to continue ironing during this process).
Select the desired amount of steam, using the appropriate button. It is possible to choose between three diffe-
rent types of intensity (zero, one, two), the choice made is visible on the display placed in front of the spray and
steam shot buttons.
The steam is produced as soon as the iron is held in a horizontal position.
Caution: take care not to come into contact with the expelled steam. Do not direct the steam jet to-
wards people and / or animals.
Warning: if the water in the tank runs out during use, wait until the iron has cooled down before
filling it again.
Warning: before using the steam, wait until the temperature has been reached, otherwise the plate
may drip because the steam is not yet ready.
Spray
As long as there is enough water in the water tank, you can use the "spray" button regardless of the set tempe-
rature, and that ironing steam or dry.
When using the iron for the first time, it is advisable to press the "spray" button few times before obtaining an
adequate spray, as the water must be able to fill the circulation pipes before exiting.
9
EN
Publicidad
