Led Light; Installing And Removing Accessories; Troubleshooting; Maintenance - Motorhead MH-03-ID-B1-0-1 Manual De Instrucciones

20V ULTRA Impact Driver 2Ah KIT (MH-03-ID-B1-0-1)
- Rotation direction
• Direction of rotation is controlled by the direction of rotation selector located above the
switch trigger.
lever to the left side of the tool.
• Left: To select reverse rotation, push the lever to the right side of the tool.
- Variable speed
• This tool has a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
• Speed is controlled by the amount of switch trigger depression.

Led Light

The LED work-light ( B in the functional description) can light prior to motor running if you
press the switch lightly, which keep the work area to be lighted for checking clearly at first,
and it lights also during your operation.
WARNING:
Do not stare directly at the light beam. Never aim the beam at any person or an object
other than the work piece.
Do not deliberately aim the beam at personnel and ensure that it is not directed towards
the eye of a person for longer than 0.25s.

INSTALLING AND REMOVING ACCESSORIES

CAUTION: Only use 1/4" hex shank bits designed for impact use. Verify bit fits the chuck
precisely before use.
• Pull Collar forward and insert an appropriate impact-rated accessory (sold separately) in
to the hex drive Chuck. Pull on bit to ensure it is secure.
• To remove, pull Collar forward, remove bit from Chuck and then release Collar.
Screw Driving
For driving fasteners, the reversing switch should be pushed to the left; for removing
fasteners, the reversing switch should be pushed to the right.
14
20V ULTRA Impact Driver 2Ah KIT (MH-03-ID-B1-0-1)

TROUBLESHOOTING

Problem Possible cause
• Unit will not start • Battery not installed properly
• Battery not charged
• Battery will not • Battery not installed into
charge charger
• Charger not plugged in
• Surrounding air temperature
too hot or cold

MAINTENANCE

Keep the tool clean using a soft damp (not wet) cloth. Do not use solvents on the plastic
parts.
Lubrication is not necessary. After long use, have an authorized service center maintain
and lubricate the tool.
Should the chuck require replacement,
Remove the battery pack
Repeat the process in reverse to install a new chuck.
To maintain the best performance of your rechargeable Li-ion battery, protect it from
overheating, both from overcharging and during storage. Occasionally charge the battery
for 1 hour. The battery may also benefit from a full discharge from time to time.
IMPORTANT: to assure product SAFETY and RELIABILITY, all mainte-nance, repairs or
adjustments (other than those mentioned in this manual) should be performed by
authorized repair centers using identi-cal replacement parts.
15
Possible solution
• Check battery installation
• Check battery charging
requirements
• Insert battery into charger
until red LED appears
• Plug Charger into working outlet.
Refer to "Important Charging
Notes" for derails
• Move charger and tool to
a surrounding air temperature
of above 39.2°F (4°C) or below
104°F (40°C)