Adler europe AD 1191 Manual De Uso página 4

device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
15. Avoid getting the device wet.
16. The device may only be wiped with a dry cloth. Do not use water or cleaning fluids.
17. The device should be kept in a dry room.
Device description (Clock speaker):
1. DISPLAY
3. Pause / Play button
5. – Button
7. Charging micro USB slot
Before powering the device on. Remove all packing material and read the instruction manual carefully. Keep it for future reference.
Setting up the device:
1. Remove all the packing material from the device.
2. Turn on the device by pressing and holding the Standby / Mode button (2)
3. The device will turn on and enter Pairing mode. (If the device will not start pairing press the Standby / Mode button (2) until you enter
Bluetooth mode.)
4. Find the speaker on your playback device. It will show as "AD 1191"
5. Press "Pair" on your playback device.
6. The speaker will emit a sound noting the pairing is successful.
7. The device is ready to use.
Charging:
1. Enter the Micro usb cable into the micro usb slot (7).
2. The device will start charging. For a full charge it takes around 3 hours of charging.
Micro SD / USB playback:
Please note the device supports files in .WAV and .MP3 format.
1. Insert the card or pen drive into the correct slot. (6,7)
2. The device will automatically enter the playback mode of the corresponding device.
3. If you want to exit the USB / SD playback press the Standby / Mode button (2) until you choose the desired mode. You can also remove
the SD / USB from the device.
3.5 mm AUX cable operation:
1. The device comes with a special AUX 3,5 mm jack to micro usb cable.
2. Insert the Jack side of the cable to your playback device.
3. Insert the Micro usb side of the cable to the speaker.
4. Press the Standby / Mode button (2) until you choose the AUX mode.
Clock setup:
1. Turn on the device by pressing and holding the Standby / Mode button (2)
2. Press the Standby / Mode button (2) until you choose the Clock mode.
3. Press the Play / Pause button (3) once to enter the time edit.
4. Press the + and – buttons (4,5) to increase and decrease the current setting.
5. Press the Play / Pause button (3) once to confirm your choice.
(Please note that after the clock you will need to set up the alarm time.)
Alarm Setup:
1. Turn on the device by pressing and holding the Standby / Mode button (2)
2. Press the Standby / Mode button (2) until you choose the Clock mode.
3. Press the Play / Pause button (3) once to enter the time edit.
4. Press the + and – buttons (4,5) to increase and decrease the current setting.
5. Set the desired time.
6. The device will enter Alarm Mode.
7. Press the + and – buttons (4,5) to increase and decrease the current setting.
8. Press the Play / Pause button (3) once to confirm your choice.
9. After the setting the display will show "SAVE"
10. The alarm is set.
Turning the alarm on and off:
1. Turn on the device by pressing and holding the Standby / Mode button (2)
2. Press the Standby / Mode button (2) until you choose the Clock mode.
3. Press the Play / Pause button (3) three times in rapid succession.
4. The alarm icon in the lower right cornet will turn on.
2. STANDBY / Mode button
4. + Button
6. SD card slot
8. Playback USB slot
4