Operation; Cleaning And Maintenance - cecotec BAMBA 04199 Manual De Instrucciones

EN

3. OPERATION

Remove the protective cap.
Press the switch to turn the shaver on.
Move the shaver gently over your skin. Make both circular and straight
movements.
Press the switch to turn the shaver off.
Clean the device by pressing the liberation button of the floating
system and then, clean the remaining hairs with the cleaning brush.
Put the protective cap on the shaver after each use.
Using the trimmer
Fig. 2.
Press the trimmer knob to open the trimmer. Place the trimmer at a
right angle (90º) to your skin and move it downward to trim sideburns
or contour.
Charging
Make sure that the device is powered off before charging it.
The red-light indicator will light up during charging and will turn green
when it is charged.
The shaver will have a 2-hour charging time.
Battery instructions
This appliance includes Li-ion batteries, do not incinerate or expose
them to high temperatures, as they may explode.
Leaks from the battery or battery cells can occur under extreme
conditions. Do not touch any liquid that leaks from the battery. If the
liquid gets into contact with skin, wash immediately with soap and
36
water. If the liquid gets into the eyes, flush them immediately with clean
water for a minimum of 10 minutes and seek medical attention. Wear
gloves to handle the battery and dispose of immediately in accordance
with local regulations.
Avoid contact between the battery and small metallic objects such as
paper clips, coins, keys, nails or screws.
Before a new battery is used or the battery is used for the first time after
long-term storage, fully charge the battery. When the device is stored
and not used for long periods of time, ensure that the battery pack is
fully charged, and ensure that the battery is charged and discharged at
least once every three months.
Do not remove the battery during charging.

4. CLEANING AND MAINTENANCE

Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.
Turn off and disconnect the device from the mains supply before
cleaning, assembling or disassembling any of its parts.
Clean the device after each use with the cleaning brush or a lightly
dampened cloth. Do not use water.
Do not use compressed air, abrasive scouring pads, powders or
cleaners to clean the product.
Do not immerse the appliance's body in water or any other liquid or place
it under running water.
Press the foil frame release button and remove the foil frame by turning
it counterclockwise. Clean the foil and the foil frame.
In order to. Remove the blades' support from the blades, turn the
EN
37