Hand Guard - Bosch 1500C Instrucciones De Funcionamiento Y Seguridad

BM 3609929809 10/03
Switch is spring loaded and will snap back
automatically.
Start the tool before applying to work and let
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is
under load; this will greatly decrease the
switch life.
Before cutting, lightly oil the cutting line.
Hold the tool at a angle 80° to 90° to the metal
surface (Fig. 2).
FIG. 2
80-90°
Get user manuals: See SafeManuals.com
10/1/03 9:05 AM Page 8
The hand guard protects the hands while
cutting, and deflects material downwards
and away from the operator. The hand guard
must be used at all times while using this
shear.
Tool Tips
Excessive feed rates reduce the performance
considerably and shorten the life of the
cutters.
Sharp cutters produce good cutting results
and protects the tool.
Do not load the tool so heavily that it stalls.
Cutting curved lines: Do not tilt the tool and
work with low feed rate.
-8-

HAND GUARD