Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing a quality unit. Used carefully and in accordance with the instructions set out below,
your SOLAR GARDEN LIGHT SYSTEM should give you many years of trouble free use. Please read the
instructions carefully to obtain the best results from your purchase.
Your units features:
Solar powered by Big size high quality crystalline solar panel
•
No Mains Power
•
Simple wiring
•
Water proof design provides longer life in all weather conditions
•
Automatic sensor turns the light on at dusk
•
3 X Spotlights with 3 meters wires
•
The spotlights can be put under cover and shade-anywhere as your want
•
6 X Rechargeable Ni-MH batteries (600mA) included to solar controller
•
Location of the SOLAR CONTROLLER
1) For the best result, please locate the solar controller in a
position where it can get direct sunlight on the solar
panel, and generally free from cover and shade. (As
shown in figure 1).
2) Make sure that the photo sensor is not going to be affected by any other light source. Otherwise the light will
not illuminate at dusk.
3) The SOLAR CONTROLLER must be left to charge for 2 sunny days before best results are achieved.
Assembly Instructions
Solar controller installation
1) Carefully remove the UNIT and all the fittings out of the box.
2) Assemble the mounting poles (2), and stakes (3); Push the stake directly into the
ground (DO NOT hammer the light or the stakes) (as shown in figure 2).
3) Slot the controller head (1) on the upper part of the mounting poles carefully.
Wires Connection
Insert plug of each spotlight, one by one to the sockets on the solar controller. (as
shown in figure 3)
- Instruction Manual -
Publicidad
