SPEX Standing Powerchair Adapter Mount Guia De Instalacion

Standing Powerchair Adapter
Mount
Installation Guide
1. Attach the hardware centrally on
the back support shell using the
Fixing Studs, M6 Flat Washers, and
M6 Nyloc Nuts.
Use a 10mm wrench to firmly
tighten the nuts.
2. Attach mount to power
wheelchair using Conical Washers
and M8 Dome Nuts.
Use a 13mm wrench to firmly
tighten the nuts.
3. Adjust back support height by
loosening M6 Nyloc nuts. When
locking back support height, ensure
fasteners are tight.
Further height adjust can be
achieved by repositioning the mount
on the back support (step 1).
CAUTION: This is not crash
certified and therefore it is not to
be used for transportation uses.
This is a supplementary installation guide,
for full information and warnings refer to
Back Support User Manual provided with
your Standing Powerchair Adapter Mount.