Closing The Race Track; Race Time - THINK GIZMOS CATAPULTING TRANSPORTER TRUCK Manual Del Usuario

3.2 Closing the Race Track

1) Collect up the race cars and place to one side.
2) Holding the handle that was inserted at step 3 when opening, gently pull upwards and towards
the truck cabin so that you have all but the track attached to the truck at a 90-degree angle.
3) The first brown section nearest to the cabin should fold over so that the top of the race track is
face down on the grey part, you should see two plastic towers sticking up, these will hold the rest
of the sections as it is folded down.
4) For the next section you have to pull the track away from the truck to ensure the grey track
surface is facing up and the light brown section is laying flat along the first section.
5) For the next section pull the track towards the cabin, similar to part 3, the race track surface
should be facing down and two small plastic towers should point up.
6) The final section should then fold on to the last section, clipping in place.
7) Click the rear tail section back into place to keep the truck together.
8) Insert the cars into the sections on the truck.

3.3 Race Time!

Once the truck race track is fully extended, ensure that the winners mark is nicely centered.
Place your selected race cars into the gap in the cabin, the front of the race car aiming down the
track, try and ensure the cars are pushed right up inside the cab.
When ready to race:
Push down on the launcher button at the top of the trucks cabin in a firm and fast motion. This
launches the cars from the top of the cabin down the race track.
The winning car will race past the winner's mark, blocking the other car from leaving the track at
the end.
Pro Tip: If you find your child is hitting the launch lever quite hard and the truck and track is lifting up slightly, get them to hold the
cab down when launching, a slight push down on the roof of the cab will stop the the track lifting up.
4