Publicidad
Operation
• Turn on the compressor and fill it.
• Regulate the air compressor output pressure to 75 PSI and 110 PSI
WARNING
The tool operates with this pressure range. If operating with a higher pressure ranges the useful life of
the tool will be decreased.
• Load the cartridge as indicated on page 7.
CAUTION
• Use a piece of scrap wood to verify the tool works correctly.
• Not putting your finger on the trigger position the tool and press the contact lock against the surface to be used (A).
• Without lifting the tool press the trigger to shoot (B).
• Immediately release the trigger and lift the tool (C).
• Position the tool back for subsequent shots.
• In case the staples are not penetrating deep enough, slightly lift the air pressure until reaching the right penetration force.
WARNING
Remember not to exceed 110 PSI
Depth regulator
CAUTION
Disconnect the tool from the air supply
before attempting to disassemble any parts.
• Loosen the screw (D) with a hex wrench.
• Move the sliding shoe (E) down (away from the tip) to
decrease the depth or up (towards the tip) to increase the
depth.
• Tighten the screw with a hex wrench.
8
ENGLISH
A
Start Up
B
E
D
Too Deep
Flush
C
Publicidad
