Publicidad
Idiomas disponibles
Idiomas disponibles
English
hands, one hand for each half of the tabletop, and slowly walk backward while pulling down gently on the
handles. Let the legs that are closest to the ground stay in place while you tip the table to an upright
position. (3)
The cables will stretch by themselves.
Folding-up procedure:
- Set the table on its edge, on the little rubber feet.
- Fold the legs gently minding that the cables are not trampled or forced.
- Get the 2 halves of the table together and lock the clasps at both edges.
Notice: in certain floor surfaces the table legs might leave marks after a prolonged contact. Check the
technical specifications of the floor manufacturer to avoid any trouble.
b) LOAD capacity
This item has been tested to support a MAXIMUM STATIC WEIGHT of 135 Kg evenly distributed all over.
Absolutely avoid leaning on the very edge for support as it may tilt over.
If pressure on a reduced area exceeds the allowed weight, the table upholstery could split up. Keep the
patients from getting on by their knees.
To get on the table the patient must seat at the middle of the table, raise his legs and lean on his side.
Then, he can lie down. Weight must necessarily be distributed evenly and not concentrated on either side
of the table.
When getting down the table different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the table, lean
on his side and go up by standing on his arms. He will then be able to put his legs out by the table's side
and easily stand up.
If the patient is lying upwards he will have to stand on his arms, get back to a seated position and then go
down the table.
* Caution: Never use the head or back rest sections to lean forward as these parts are not aimed at
supporting such a pressure.
c) HEIGHT adjustment
1. Unscrew and pull out the C nuts.
2. Slide up or down the B leg extention.
3. Get the A bolt in the chosen hole of the leg extention.
4. Screw in the C nuts.
* Notice: before using the table, make sure all legs are fixed at the same height.
d) ACCESORIES Adjustment
The table you've bought includes the FACE CRADLE A4430.
It is stored underneath the upholstery and fixed by means of 3 clamps. To remove the face cradle simply
hold the metal frame and pull.
To install the face cradle, insert the bolts through the holes provided at the edge of the table.
You can adjust the cradle tilt by loosening the grips, then place it at the required position and tighten the
grips.
8
Publicidad
