Servicing Of A Double-Insulated Appliance - NORAUTO HP100 Manual De Instrucciones

• Always turn the water supply "on" before turning the power washer power to "on".
Running the pump dry will cause damage to the internal components.
• Never use a water supply to your power washer that exceeds 10 bar maximum.
• Never disconnect the high pressure hose from the power washer while the system is
pressurized.
• Never permanently engage the trigger mechanisms on the spray gun.
• Never operate the power washer unless all components are properly and securely
connected.
• Never allow the power washer pump to run for more than one minute, after you have
turned off the water supply. This can cause the motor and pump to overheat and fail.
• Never use lances or other parts that have not been supplied with your power washer.
• Never spray any electrical outlet with your power washer.
• Inspect the power cord before using. Do not use it if it is damaged.

SERVICING OF A DOUBLE-INSULATED APPLIANCE

In a double-insulated product, two systems of insulation are provided instead of
grounding. Grounding means are not provided for a double-insulated product,
nor should grounding means be added to the product.
Servicing a double-insulated product requires extreme care and knowledge of
the system, and should only be done by qualified service personnel.
Replacement parts for a double-insulated product must be identical to the original parts.
A double-insulated product is marked with the words "Double Insulation" or "Double Insu-
lated". Product may also be marked with symbol shown below.
CAUTION READ THE INSTRUCTIONS BEFORE USING THE MACHINE.
Machines shall not be used by childrew. Children should be supervised to
ensure that they do not play with the machine.
Appliances can be used by persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision or instruction concer-
ning use of the appliance in a safe way and understand the hazards involved.
The electric supply connection shall be made by a qualified electrician and comply with IEC
60364-1. It is recommended that the electric supply to this machine should include either a
residual current device that will interrupt the supply if the leakage current to earth exceeds
30 mA for 30 ms or a device that will prove the earth circuit.
– If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
– WARNING Do not use combustion engine powered machines indoors unless adequate
ventilation is assessed by national labour authorities.
– WARNING Ensure that any exhaust emissions are not in the vicinity of air intakes.
– WARNING This machine has been designed for use with the cleaning agent supplied or
recommended by the manufacturer. The use of other cleaning agents or chemicals may
adversely affect the safety of the machine.
– WARNING High pressure jets can be dangerous if subject to misuse. The jet must not be
directed at persons, live electrical equipment or the machine itself.
– WARNING Do not use the machine within range of persons unless they wear protective
clothing.
– WARNING Do not direct the jet against yourself or others in order to clean clothes or
foot-wear.
– WARNING Risk of explosion - Do not spray flammable liquids.
– WARNING High pressure cleaners shall not be used by children or untrained personnel.
– WARNING High pressure hoses, fittings and couplings are important for the safety of the
machine. Use only hoses, fittings and couplings recommended by the manufacturer.
EN
30