General Safety Rules - Waterco TURBOFLO AQUA 8000 Manual Del Usuario

GENERAL SAFETY RULES

1. The machines mentioned in the manual are specially designed for the pre-filtering and re-circulation of
water in swimming pools.
2. They are designed to work with clean water at a temperature not exceeding 50 degrees Celsius (122
degrees Fahrenheit).
3. The installation should be carried out in accordance to the safety instructions of swimming pools,
especially Standard HD 60364-7-702, and the specific instructions for each facility.
4. The rules enforce on accident prevention should be carefully followed.
5. Any modification of the pump requires the prior consent of the manufacturer. Original replacement
parts and accessories authorized by the manufacturer ensure a high level of safety. The manufacturer
of the pump assumes no liability for the damage and injuries caused by un-authorized replacement
parts and accessories.
6. During operation, some parts of the pump are subject to dangerous electric voltage. Work may only
be performed on each pump or on the equipment connected to it after disconnecting them from the
mains power, and after disconnecting the starting device.
7. The user should make sure that assembly and maintenance tasks are carried out by qualified authorized
persons and that these persons have first carefully read the instructions for service and installation.
8. The operating safety of the pump is only guaranteed if the installation and service instructions are
correctly followed.
9. The limit values stated in the. Technical table should not be exceeded under any condition.
10. In the event of defective operation or fault, contact the technical support department of the
manufacturer or its nearest authorized agents.
11. If the supply cord is damaged, it must be replaced by an authorized service agent.
12. This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
13. The appliance is not intended for use by young children. Young children should be supervised to
ensure that they do not play with the appliance.
~ IMPORTANT ELECTRICAL NOTICE ~
The electrical installation is to be done by a licensed electrician.
Each pump requires a circuit breaker to separate the pump from the electrical supply.
The contact separation has to provide full disconnection in all poles under overvoltage
category III conditions.
If the pump is to be installed on a swimming pool or pond situation it is MANDATORY that an
earth leakage circuit breaker with a rated tripping current not exceeding 30mA be installed.
Check the pumps name plate for the following: Voltage, Amp draw and Cycle.
The power cord, including the ground wire shall have a quality of 60245 IEC 66 (H07RN-F)
for models greater than 1kW power input.
For models less than 1kW input the quality shall be of 60245 IEC 57 (H05RN-F).
All installations must comply with local codes, based on IEC 60364-7-702 requirements.
Waterco Pumps I pg 02