Tonka MIGHTY MONSTER Manual De Instrucciones página 3

4. Connect adapter to a USB power source with a maximum of 7.4V output. (5V is
standard for wall adapter/computer)
5. Upon completion of charging, unplug the USB cable adapter and re-connect it back to the
vehicle power cord. Reinstall battery cover.
PAIRING/OPERATION
1. To sync the remote to the truck, turn the vehicle on and press down on the power button
located on the controller.
2. When correctly synced, the light located above the power button on controller will be solid
red, and light near power switch on vehicle will be solid red.
Controller On/Off
Forward
Reverse
Lower
Dump
Bed
BATTERY INSTALLATION FOR CONTROLLER
1. Using a Phillips/crosshead screwdriver (not included), loosen the screws in the battery
compartment cover (screws stay attached to cover.) Remove the cover. Insert 2 x 1.5V "AAA"
size batteries.
2. Alkaline batteries recommended. Replace cover and tighten screws.
Pairing Indicator
360° Spins
Remove battery cover with
Phillips-head screwdriver
(not included).
Left
Right
Dump
2 ×1.5V AAA/R03
(Not Included)
Requires 2 x 1.5V AAA/LR03 batteries
Increase/
Decrease
Speed
Lift
Bed