Configuring The Unit In Dbswin - Air Techniques ScanX Swift View Instrucciones Para Montaje Y Uso

Installation
EN-
Mark the connected unit in the list.
❯
US
Click on Edit connection settings.
❯
The unit name (designation) can be changed
❯
and information queried in General.
An IP address can be entered manually and
❯
DHCP can be activated / deactivated in Con-
nection.
Extended functions e. g. IP address 2 can be
❯
set in Extended.
Entering a permanent IP address (recom-
mended)
To reset the network settings, keep the
unit reset key pressed for 15 - 20 sec-
onds while switching on.
Deactivate DHCP in Connection.
❯
Enter the IP address, subnet mask and gate-
❯
way.
Navigate back to Units via the navigation bar
❯
or close Flyout using
This saves the configuration.
Testing the device
You can scan an X-ray image to check if the unit
is properly connected.
Open VisionX.
❯
Create an X-ray station for the connected unit.
❯
Log-in the demo patient (patient ID:
❯
DEMO0001).
Select the acquisition type (e. g. Intraoral).
❯
To scan a PSP, see "11 Operation".
❯
22
.
8.3 Configuring the unit in
DBSWIN
The configuration is done with VistaConfig, which
is automatically installed during the installation of
DBSWIN or VistaEasy.
Start > All Programs > Air Techniques > Vis-
❯
taEasy > VistaConfig.
Click .
❯
This updates the list of connected devices.
If the device isn't found, enter the IP address
❯
manually and click Register device manually.
Activate the connected device in the Regis-
❯
tered column.
You can also register multiple devices.
Use the ScanX device configuration window to
change the device name, (name), to manually
enter an IP address and to request information.
Click .
❯
2142100008L41 2202V007