VONROC LL503DC Traducción Del Manual Original página 7

Using the tripod (not included)
1. Place the device with the 1/4" tripod
connection (4) on the thread of the tripod or a
conventional camera tripod.
2. Roughly align the tripod before switching on the
device.
4. OPERATION
Only the centre of the laser line must be
used for marking. The width of the laser line
changes depending on the distance.
It's recommended to carry out an accuracy
check before first use and periodic checks
during future use, especially for precise
layouts. Also when the laser may have been
dropped.
Danger of injury due to defective
components! The product must only be put
into operation if no defects are found.
Ensure that any defective parts are
replaced before the product is used again.
WARNING! Risk of injury due to laser beam!
Never direct the laser beam towards people,
other living creatures or reflecting surfaces.
Charging the device (Fig. C)
The device must be charged before first
use.
1. Plug the USB type-C plug (10) into the USB
type-C connector (13) on the device.
2. Plug the USB type-A plug (12) into an power
adapter (not included) or device (e.g. computer,
powerbank) with suitable female USB
connector. Please note that the device should
be able to deliver constant 5V 2A power.
3. The Battery LED indicator (5) will lighten up and
show the charging status.
LED Charger status
Red Battery charging in progress
Green Charging finished, battery fully charged
4. After the battery is fully charged remove the
USB type-C plug (10) from the USB type-C
connector (13).
WWW.VONROC.COM
It is also possible if the battery is empty to
power the device with the charger or with a
power bank. Follow the steps as above.
When the device is not being used over a
longer period of time it is best to store the
battery in charged condition.
Check the device:
• Make sure all parts are fitted on the machine
firmly.
• Check whether there are any visible defects:
broken parts, cracks, etc.
• Check the accuracy when it is the first time you
are using the laser or when the laser has not
been checked for accuracy in a while.
• Also check the accuracy when the laser may
have been dropped.
Self- levelling mode (Fig. A, D1)
The lasers are aligned automatically by the
pendulum so that the vertical and horizontal lines
are displayed level on the wall.
1. Place the laser on a flat surface or fit it to the
universal clamp (7) or tripod (not included) and
fasten it as described above.
2. Slide the lock switch (2) to the right. Press the
ON / OFF button (1) on the device to power on.
If the laser flashes, the permissible inclination
range of 5 degrees is exceeded. Position the
device horizontally until the laser stops flashing.
3. To switch off, slide the lock switch (2) to the left
and press the ON / OFF button (1). The laser
switches off and the pendulum will be locked.
Slide the lock switch (2) to the left when
transporting it. This locks the pendulum
unit, as it can otherwise be damaged.
Manual mode (Fig. A, D2)
The laser can be aligned manually to the angle you
require, to enable for example a diagonal line to be
displayed.
1. Place the laser on a flat surface or fit it to the
universal clamp (7) or tripod (not included) and
fasten it as described above.
2. Check if the lock switch (2) is set to the left. If
not, slide the lock switch (2) to the left.
3. Press the ON / OFF button (1) to switch the
EN
7